MIS-BEP24-IP66-WEB
Wall splice box IP66 24 x FO
IP66 wall splice box 24 x FO - The Laser 2000 BEP-24 wall splice box has been designed for a maximum of 24 FO plugs.
Installation
1
Installation
FOV-Vorlauffaser-Ring
Pre and post fiber ring
Lead and lag fibers are used to adapt the meter to the target. The use of a launch fiber protects the adapters on the meter and evaluates the start or end events.
MIS-ORMP-
ORMP 1U/ 2U Draw-out-type ODF
ORMP 1U Draw-out-type ODF. The ORMP draw-out-type ODF is designed for the placement of 24 optical connectors indoors. The design of the patch panel enables to install it into a 19” rack.
IMM-Fiberpoint-250
Fiber Optic Fault Locator
Robust and easy-to-use laser light source with long battery life for troubleshooting fiber optic lines, connectors, etc. with universal adapter for 2.5 mm ferrule.
IMM-Fiberpoint-250HP
Fiber Optic Fault Locator (high power)
Robust and easy-to-use laser light source with long battery life for troubleshooting fiber optic lines, connectors, etc. with universal adapter for 2.5 mm ferrule.
FLK-LIQ-100
Network & Service Companion
Cable tests you can trust. Network tests you need. Measure network capacity up to 10 Gig via frequency-based measurements with the new LinkIQ from Fluke Networks.
FLK-FI-3000
FiberInspector Ultra MPO
The FI-3000 FiberInspector™ Ultra is the industry's most complete fiber inspection solution.
Popular Products
DAT-WinCamD-LCM
Laser Beam Profiler WinCamD-LCM
This laser beam profiler features a CMOS sensor that guarantees frame rates of up to 60 Hz with high dynamics and is suitable for large beam diameters up to 11 mm.
DAT-WinCamD-IRBB
2-16 micron Laser Beam Analyzer
The beam analysis camera WinCamD-IR-BB with integrated microbolometer array enables analyzes on long-wave lasers in the range of 2 μm to 16 μm.
DAT-WinCamD-QD-1550
Laser Beam Profiler WinCamD-QD-1550
This Laser Beam Profiler from DataRay is equipped with a CQD sensor and offers a spectral response in the SWIR range of 400 - 1700 nm with resolutions up to 1920 x 1080 pixel.
DataRay's ILM system is used for beam profile monitoring of high power lasers consisting of an attenuator for high powers, an imaging lens system and a camera system. The measurement of very small laser beams with diameters of less than micrometers is possible despite often high laser powers.
