The EOP-PLD-1S-110 driver is a boxed driver for 110 V. The driver has front panel controls for amplitude and phase and internal power supplies.
Filters
!shop!_Type
- Drivers - Lock-In Amplifiers
1
The EOP-PLD-1S-220 driver is a boxed driver for 220 V. The driver has front panel controls for amplitude and phase and internal power supplies.
The EOP-PLD-1S-PC driver is a printed circuit board level driver which requires an external ± 15 V dc power supply.
The EOP-PLD-2S-110 driver is a boxed driver for 110 V. The driver has front panel controls for amplitude and phase and internal power supplies.
The EOP-PLD-2S-220 driver is a boxed driver for 220 V. The driver has front panel controls for amplitude and phase and internal power supplies
The EOP-PLD-2S-PC driver is a printed circuit board level driver which requires an external ± 15 V DC power supply
SCT-Lock-In Amplifier
Lock-In Amp
Matching the chopper complete systems and individual components offered by us, we offer Lock In amplifiers for data acquisition.
SCT-410 is a single phase analogue lock-in amplifier. It is suitable for making amplitude and phase measurements.
SCT-420 is a dual phase analogue lock-in amplifier. This amplifier is suitable for making amplitude and phase measurements.
A single phase lock-in amplifier with manual setting, using jumpers, of input mode, sensitivity, low pass filter time constant and reference signal course phase control.
A dual phase lock-in amplifier with manual setting, using jumpers, of input mode, sensitivity, low pass filter time constant and reference signal course phase control.
Popular Products
This laser beam profiler features a CMOS sensor that guarantees frame rates of up to 60 Hz with high dynamics and is suitable for large beam diameters up to 11 mm.
The beam analysis camera WinCamD-IR-BB with integrated microbolometer array enables analyzes on long-wave lasers in the range of 2 μm to 16 μm.
This Laser Beam Profiler from DataRay is equipped with a CQD sensor and offers a spectral response in the SWIR range of 400 - 1700 nm with resolutions up to 1920 x 1080 pixel.
DataRay's ILM system is used for beam profile monitoring of high power lasers consisting of an attenuator for high powers, an imaging lens system and a camera system. The measurement of very small laser beams with diameters of less than micrometers is possible despite often high laser powers.
