Filters
!shop!_Type
- Polarizers - Polarizing Beamsplitter
Polarizers
Polarizing plate beamsplitters are plates that have a polarizing coating. These transmit p-polarization and reflect s-polarization because the incoming monochromatic beam is at the Brewster angle.
These Polarizing beamsplitters consist of two right angle prisms. One of them is coated with dielectric multi-layer polarizing coating on the hypotenuse face.
Broadband Polarizing Beamsplitters provides wide band polarizing.
Polarizing beamsplitters split a monochromatic beam entering at zero degree into p-polarization as transmitted and s-polarization as reflected radiation.
These are special polarizers with minimal transmission loss. Calcite can be used in the visible to infrared range.
Glan Laser Polarizers are designed to provide enhanced laser damage threshold for high power lasers and high energy laser pulses. Calcite can be used in the visible to infrared range.
Transmission loss is minimal, and a high extinction ratio below5x10^-5 is claimed. Calcite can be used in the visible to infrared range.
These are prisms for splitting the incident beam into two linearly polarized beams with orthogonal polarization direction. Calcite can be used in the visible to the infrared range.
The polarizer separates the incident light into two linearly polarized light beams that cross perpendicularly.
The polarizer separates the incident light into two linearly polarized lights that cross perpendicularly.
By using a dichroic dye sheet, good linear polarization can be achieved over a wide range.
By using a dichroic dye sheet, good linear polarization can be achieved over a wide range.
Popular Products
This laser beam profiler features a CMOS sensor that guarantees frame rates of up to 60 Hz with high dynamics and is suitable for large beam diameters up to 11 mm.
The beam analysis camera WinCamD-IR-BB with integrated microbolometer array enables analyzes on long-wave lasers in the range of 2 μm to 16 μm.
This Laser Beam Profiler from DataRay is equipped with a CQD sensor and offers a spectral response in the SWIR range of 400 - 1700 nm with resolutions up to 1920 x 1080 pixel.
DataRay's ILM system is used for beam profile monitoring of high power lasers consisting of an attenuator for high powers, an imaging lens system and a camera system. The measurement of very small laser beams with diameters of less than micrometers is possible despite often high laser powers.
A main feature of the WinCamD is the optional M2 Stage. Thus, it can be easily extended to a complete M2 measurement system.